300 prc brass Overview:
300 prc brass begins with high-quality raw materials and superior smelting and metallurgical competence.
Throughout the production process, the focus on quality control is consistent with Lapua’s exacting standards.
Particular attention is paid to hardness, solidity and grain structure.
All 300 prc brass is tested to 30% overpressure according to Commission Internationale Permanente, the agency that oversees ammunition and component producers in Western Europe.
This is not loaded ammunition.
300 prc Brass Preparation:
With bulk rifle brass you may sometimes notice a few case mouths are “out of round” or slightly dented below the shoulder.
These imperfections occur in the final tumbling wash operation after the case mouth has been annealed.
Brass manufacturers are aware of the case cosmetics and have worked to mitigate it, but due to equipment design, denting may still occur.
Minor dents are normally removed in the first firing and will not affect case life or performance.
On non-plated brass, you may also notice all the anneal stain might not be polished off, which may give the case neck a pinkish color. With some smaller caliber cases you may notice the case mouths to be slightly belled.
With all new rifle brass, you should first straighten out the case and case mouth, then chamfer and debur the case mouth inside and out.